Job offersmore »
- Service Engineer - US & Canada
- Inside Sales Coordinator - USA
- Sales Engineer, Water - The Netherlands
- Crop care supervisor - Australia
- Nursery Systems Manager - Australia
- GENERAL / FARM MANAGER - India
- Grower / Ag scientist - Australia
- Technical/ Product Representative, Russia
- Technical/ Product Representative, India
- Retail Chain Manager - Russia
Top 5 - yesterday
Top 5 - last week
Top 5 - last month
- US(PA): 60,000 sq.ft. vertical greenhouse to bolster Lancaster's less fortunate
- "Energy storage is more than just batteries"
- Leaf sensors can tell farmers when crops need to be watered
- Paskal launches cloud-based irrigation monitor solution
- Inefficient cannabis growers will go out of business eventually
Exchange ratesmore »
Common greenhouse maintenance problemsMost common greenhouse maintenance problems are caused by neglect. Itís not that growers or nurseries deliberately leave maintenance until itís too late; rather, they tend to be so busy that arranging for it to be done, or doing it themselves, gets put off to a more convenient time. The trouble is, thereís never a more convenient time. The most common problems come from a lack of cleanliness and faulty equipment. You probably knew about the latter, but perhaps didnít give much thought to the first one.
In a greenhouse, everything gets dirty. Unless youíre using hydroponics or some other growing medium, soil is literally at the root of everything you cultivate. And it has a way of finding itself onto many of the surfaces under glass. As if that wasnít enough, the glass itself also gets dirty. Water vapour is distributed around the glasshouse, condenses on the inner surfaces, and then when it evaporates, leaves condensation nuclei behind. On the outside, standing water encourages the growth of fungi and attracts pests. Aluminium-framed greenhouses accumulate dirt in the joints between panes of glass and also where the glass comes in close contact with the framing itself. Once the dirt and grime is allowed to settle, it can attract pests and mould. And as the weather worsens, so will the problems associated with it.
Keeping your glasshouse clean
The most effective way to clean glass and other surfaces is with a jetwash in-between seasons, when the glasshouse is likely to be empty or nearly so. Gutters are a nuisance to clean out and probably best left to the experts who are used to climbing up and onto greenhouses. You certainly donít want to fall through the glass roof. That said, you can sweep the floors anytime, and doing so as you go makes the job a lot easier than waiting until itís really a mess. Disinfectants are another thing that must be handled by those who really know what theyíre doing. If youíre not sure or havenít done it before, then itís probably a good idea to get someone to do it for you. Chemicals can be dangerous if they are mishandled.
Everything in a glasshouse, including the structure itself, can break or malfunction. That means that you need to constantly be on the lookout for problems and get them fixed as soon as possible.
Heaters tend to corrode when pipes leak. Itís much cheaper to catch a leak early than to wait until it becomes a steady drip or worse. You also want to make sure you have enough fuel stored up before you need it. Buy it during the off-season. Then youíll have it when you need it.
Door and window seals should be checked each season. They tend to break down with use and from changes in the weather. Grease your racks and pinions, too; at least annually. And check your windows periodically to make sure that the close all the way. Do this at least every season. You want to find out that they donít seal properly before the cold weather sets in; not after.
Screens also wear with use. Be sure you check them for tears and holes. You donít want one coming apart when you need to open it, especially if it occurs on one of those days where the sun is in and out of the clouds.
Keep fans free of the dirt and gunge that builds up from excessive lubrication. Wherever there are moving parts, apply only as much as you need to do the job; and be sure to wipe off the excess when youíre finished.
Check everything that transports or stores water for leaks or cracks. Remember that water ďfinds its own levelĒ, so you may have to do some investigating to find the actual source of the problem.
Check for cracked or broken glass and replace damaged panes as soon as you notice them. Gaps can let insects in, and water that freezes in the cracks can make the situation much worse. Look over all of your glasshouse; not just in the obvious high use areas. Itís worth taking a close look after a day of high winds or a strong storm. Look especially for signs of corrosion or breaks in the metal itself.
There are likely to be parts of your glasshouse that you donít visit very often. Donít overlook these. Check your wires, for example, for evidence of wear and gnawing. If you happen to have a back-up power supply, then run it at least once per year so that youíre confident that it works. And check your lights. LEDs and high-efficiency bulbs last longer than the old tungsten lamps, but nothing lasts forever. Inspect these things before you need them.
Itís been said that that an ďounce of prevention is worth a pound of cureĒ, and thatís certainly the case when it comes to your glasshouse and the equipment that you use with it. The easiest way to prevent problems from occurring is to follow a routine inspection schedule. If you do a little bit each week or every couple of weeks, then it wonít take you more than a few minutes at a time. Create a routine that works for you. and then put it into practice. You can even delegate the easy stuff. The goal, of course, is to prevent downtime. If you think youíre too busy to inspect your equipment, then think about what you stand to lose if your equipment broke down for a couple of hours, a day or longer.
For more information:
20 Harwich Road
T: +44 (0) 1206 230 729
F: +44 (0) 1206 231 109
Publication date: 9/12/2017
Other news in this sector: