Job offersmore »
- Account Manager, Southern, Protected Cropping - Melbourne, Australia
- Coördinator Biologische Gewasbescherming - Berkel en Rodenrijs, Nederland
- Head Grower, Retractable Roof Shadehouse - Wedgecarrup, Australia
- National Nursery Manager - Melbourne, Australia
- Lighting Applications Specialist (Horticulture) - Beamsville, Ontario, Canada
- Gärtner für den konventionellen Gemüsebau - Austria
- Expert vegetable farm manager/master grower seeking for his next position
- Horticulture Advisor - The Hague, the Netherlands
- Growing Manager - Victoria, Australia
- Service Engineer - Almeria, Spain
Top 5 - yesterday
Top 5 - last week
Top 5 - last month
Exchange ratesmore »
US (MI): Managing substrate pH of soilless substratesDid you know different substrate components in soilless mixes have different pHs? Peat moss and aged pine bark only have a natural pH between 3.0 and 4.0. The optimal substrate pH for most greenhouse and nursery crops, however, is between 5.4 and 6.4 (Figure 1). Therefore, soilless substrate manufacturers add calcitic, dolomitic or hydrated limestone or calcium sulfate to raise the pH into that optimal pH zone.
Figure 1. The optimal substrate pH for most greenhouse crops is between 5.4 and 6.4. Figure by Garrett Owen, MSU Extension.
Every year, Michigan State University Extension floriculture and nursery crops educators encounter situations where the pH of the substrate is either too high or too low for the crop being grown. With over 1,500 species of ornamental plants being grown by Michigan growers, it can be complicated to not only know the pH and electrical conductively (EC) requirements for each crop, but how to grow them effectively using similar media components.
Nutritional disorders can exhibit very different symptoms on different species of plants. For example, one sample of New Guinea impatiens (Figure 2) from last season had lower leaf chlorosis, marginal black spotting, and the dying of leaf tissue. These symptoms are often misdiagnosed and the growers subsequently do not correctly address the problem. In this case, the substrate pH of the New Guinea impatiens plants were 4.6 (recommended 6.0 to 6.5). The low pH caused the iron (Fe) and manganese (Mn) to be overly available to the plant causing a Fe and Mn toxicity. Without testing, this problem may have been misdiagnosed because we often see nutrient deficiencies related to high substrate pH often caused by the very high water alkalinity.
Figure 2. Symptoms of iron (Fe) and manganese (Mn) toxicity because of low substrate pH on New Guinea impatiens. Photos by Garrett Owen, MSU Extension.
There are a few options to correct low pH:
- Apply flowable lime at the rate of 1 to 2 quarts per 100 gallons of water. Be sure to rinse foliage.
- Apply a 1:15 solution of hydrated lime. To do this, mix 1 pound per 3 to 5 gallons of warm water and stir thoroughly.
- Apply potassium bicarbonate (KHCO3) at the rate of 2 pounds per 100 gallons of water. Be sure to rinse the foliage of the plant immediately, leach the substrate and do not over apply.
Source: MSU Extension (Heidi Lindberg and W. Garrett Owen)
Publication date: 1/9/2018
Other news in this sector: